jacko996

iTrader: (2)

Hi all

I want to measure EGT and looking for best options.

I got the sensor below but the probe is very long and would not like this in the manifold (very obtrusive) and hate to think what would happen if it broke off!!,

I know it can be bent, but thinking there must be better probes available?? this one would be better in the down pipe after the turbo, but would ideally like to monitor all 4 cylinders at the manifold.

Any suggestions welcome.

pa_sjo

You run a long sensor to get the cable etc away from the heat of the exhaust.

jacko996

iTrader: (2)

How much of the probe needs to be inside the manifold? + if you had 4 of these sticking out all over the place would be very messy

KSA-Cossie

iTrader: (4)

Mike r does egt gauges , prices on his website lol.

pa_sjo

They usually are 'messy' :

KSA-Cossie

iTrader: (4)

Spaghetti junction. Look like type k probes.

jacko996

iTrader: (2)

Is there a system that can monitor all 4 sensors??

pa_sjo

Innovate do a 4 channel TC amp.

cossiemanden

sensor tip only need to be a few milimeters inside, it´s the tip that measures,