3FRD

iTrader: (2)

Hello Folks,

At the start of next year I am going to be taking the engine out of my Cosworth and getting it rebuild.

Whilst it's getting rebuild I'm going to do a mini restoration. Going to get the complete shell repainted including the engine bay and replace the drivers side floor section as it's getting a bit thin around where it has been jacked up over the years. Then buff the complete floor down and seal it again.

I'm looking to purchase the following parts:

2 x rear arches
Drivers side floor section and jacking point
Bootlid

Could someone put me in the correct direction as to where I can buy these parts from?

Thanks, Stephen

CRAIG HAYTER

cosworth shop on ebay or direct from cosworth they may HAVE THEM ebay may be your best bit

The Youth.

iTrader: (1)

cosworth are an engine manufacturer and have fook all to do with body panels!!

try your local ford dealer or if not hadrian panels

http://www.carpanels.co.uk/


steve

tabetha

I used Hadrian rear arches as well as other panels on mine and they were ace quality apart from the bonnet, the inner skin was not firmly attached to the outer skin so flexed a bit.
I spent over £250 on Hadrian and would happily get Hadrian again.
My bodywork was done by a repair estimator for NU, and he recomended these.
tabetha

neil andeRSon

iTrader: (3)

i don't think that any body does the floor section's. i'm just patching mine. the arch repair section's are on ebay.

http://shop.ebay.co.uk/items/_W0QQ_d...rear&_osacat=0