did rods car make it onto the dyno today?
#8
PassionFord Post Whore!!
#10
Testing the future
#14
PassionFord Post Whore!!
No not today, I have biult the engine bar the sump which will go on tomorrow,
The problem we have is Simon is flat out on the dyno which means we are unlikely to run it before monday unless we find somewhere else, we should know tomorrow on this.
Mark
The problem we have is Simon is flat out on the dyno which means we are unlikely to run it before monday unless we find somewhere else, we should know tomorrow on this.
Mark
#15
Happily retired
Ive done a dummy build of all the Fabrication etc & all fits OK .
The strut brace is the only bit that dont fit & will be sorted later.
Will crack on with removing the dummy engine tomorrow & then the brakes & fitting the Nitrous system .
Mark & I are working very hard on this & I forget im 62 sometimes when im crawling about under the motor & doing 8+ hour days, retirement should be a time of taking it easy .
We have done our bit, but it could be that things outside our control stop us making Fighting Torque .
Still, not all over yet & tomorrow Mark will try to sort something out.
Rod
The strut brace is the only bit that dont fit & will be sorted later.
Will crack on with removing the dummy engine tomorrow & then the brakes & fitting the Nitrous system .
Mark & I are working very hard on this & I forget im 62 sometimes when im crawling about under the motor & doing 8+ hour days, retirement should be a time of taking it easy .
We have done our bit, but it could be that things outside our control stop us making Fighting Torque .
Still, not all over yet & tomorrow Mark will try to sort something out.
Rod
#17
PassionFord Post Whore!!
Thread
Thread Starter
Forum
Replies
Last Post
track.focus'd
Restorations, Rebuilds & Projects.
26
12-08-2015 05:53 PM
yawiejon
General Car Related Discussion.
15
09-08-2015 06:36 PM