Uk supplier for a T3 flange
#41
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Originally Posted by Red16
Originally Posted by turbospud1
can he do the head flanges too?
#42
PassionFord Post Whore!!
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Originally Posted by Chip-3Door
Fiecos dan, 10 bolts holes mate, what I want is basically the gasket that goes into the plenum but 12mm thick
so basically just a plenum spacer. and a blanking plate.
is it for a turbo or a nos car? as i think 6-8mm will be the least you want for a blanking plate.
#43
10K+ Poster!!
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Originally Posted by Fiecos Dan
a hand drawing will be fine, and then it will be put on CAD.
Originally Posted by turbospud1
Originally Posted by Red16
Originally Posted by turbospud1
can he do the head flanges too?
![Wink](https://passionford.com/forum/images/smilies/icon_wink.gif)
#44
![Default](https://passionford.com/forum/images/icons/icon1.gif)
Originally Posted by Fiecos Dan
Originally Posted by Chip-3Door
Fiecos dan, 10 bolts holes mate, what I want is basically the gasket that goes into the plenum but 12mm thick
so basically just a plenum spacer. and a blanking plate.
is it for a turbo or a nos car? as i think 6-8mm will be the least you want for a blanking plate.
Turbo and nitrous mate, the backing plate will be bolted onto a throttle body manifold that is held by 16 bolts though so offers a fair bit of support, but yeah 6-8 sounds like a good idea, just in case.
Thread
Thread Starter
Forum
Replies
Last Post
Focosmitch
Ford Focus RS Parts for Sale.
1
02-06-2016 06:46 PM