Chassis pulling - any experts
27-07-2007, 10:53 AM
#1
I've found that life I needed.. It's HERE!!
Thread Starter
Join Date: Aug 2004
Location: UK
Posts: 1,096
Likes: 0
Received 0 Likes
on
0 Posts
Chassis pulling - any experts
Right, I got a low milage 2005 land rover discovery thats been rear ended by something big when parked up.
Bodywork is a mess but the chassis looks like it took a fucking great big wack.
The whole chassis has skewed on the left hand side, and the box section has kinked just after the beam that holds the rear diff in place.
Ive got a sealey 10 ton body dozer and I'm trying to pull it out. But the body dozer keeps breaking the welds on the pieces that wedges against the oppisite chassis rail. This is one hard mother fucker of a chassis!
Any ideas/tips/advice, apart from break the fucking car for parts!?
Top quality picasso sketch to give you an idea of where its fucked!
Dozer is the same as this :
Bodywork is a mess but the chassis looks like it took a fucking great big wack.
The whole chassis has skewed on the left hand side, and the box section has kinked just after the beam that holds the rear diff in place.
Ive got a sealey 10 ton body dozer and I'm trying to pull it out. But the body dozer keeps breaking the welds on the pieces that wedges against the oppisite chassis rail. This is one hard mother fucker of a chassis!
Any ideas/tips/advice, apart from break the fucking car for parts!?
Top quality picasso sketch to give you an idea of where its fucked!
Dozer is the same as this :
Thread
Thread Starter
Forum
Replies
Last Post
DavidK
Ford Sierra/Sapphire/RS500 Cosworth
1
27-09-2015 02:55 PM