iv got a front mount this weekend can any one tell me how to fit it i dont wont to cut all the front bumper out i know i will have to trim a bit off the back but wot els will i have to do thanks in advace its on a s2 90 spec

 

Why oh why oh why!!!

This has all been tried. A Front mounted cooler like that will not fit without major major modification.

Put it back on Ebay IMO and buy one of the known ones that were made for the job, like GRS.

 

You're gonna have fun because the entry/exit pipes on that are on different sides, so you will need a load of custom hoses made up.
did it come with anything, what is it? Is it just a generic IC or specifically for a ERST?!

 

just got the intercooler nothing with it i know i will have to have a revers charge carrier and was thinking of getting some stainlees pipe bent for it and ther is no name on it any wher

 

It's most probably an XS Power job off Ebay. You won't get anyone to make you Stainless pipes for it and to do it with Silicone and Joiners will just end up with so many scruffy joins that it won't be air-tight and you will wish you had just bought the proven GRS cooler.

 

From experience mate I would go for a Pro alloy one custom made to your requirements.

Thing is you have saved money there buying that one but you will need to spend a good 100-200 quid in hoses and stainless pipe.

You want the shortest route possible ideally to maintain a good flow rather than a figure of 8 pattern of tubes etc.

I think Pro alloy make a custom one for around 350 ish and will make it exactly how you want.

Worth giving them a call

 

ok thanks for the help

 

Ghd's work well though im told

 

just wont to point out ther not mine lol but i bet they all say that lol

 

How can they not be yours when your a known tranny

 

is ther no wher i can go with out you telling every one my secert