Long shot...fork oil vfr400 nc24
#1
Long shot...fork oil vfr400 nc24
..you never know!
..noticed on braking heavy the forks bottom out...seal are fine so i can only think they need some more oil....so i have got the tops off (forks still on bike!) but dont know how to measure so i get the right amount?????
..noticed on braking heavy the forks bottom out...seal are fine so i can only think they need some more oil....so i have got the tops off (forks still on bike!) but dont know how to measure so i get the right amount?????
#2
10K+ Poster!!
are there any imperfections in the surface of the forks? whereby oil could be allowed past the seals when the forks are moving up and down.
it'd also be worth changing the seals while its apart, get them for a few quid from the same place you got the oil from probably.
give these a bell, they resealed my forks on the srad a few years ago and made a nice job, sure they'll dish out a bit advice over the phone
Armstrong Engineering
176 Westgate Road
Newcastle Upon Tyne
Tyne and Wear
NE4 6AL
Tel: 0191 261 4579
it'd also be worth changing the seals while its apart, get them for a few quid from the same place you got the oil from probably.
give these a bell, they resealed my forks on the srad a few years ago and made a nice job, sure they'll dish out a bit advice over the phone
Armstrong Engineering
176 Westgate Road
Newcastle Upon Tyne
Tyne and Wear
NE4 6AL
Tel: 0191 261 4579
Thread
Thread Starter
Forum
Replies
Last Post