Fudgey

iTrader: (4)

If i get time this week, i think ill make a start on the engine build of my ZT. firstly i need to lap the valves in and stuff, then assemble the head.

what is the best way to fit the valve stem seals?? is it to place them on and the drive them home with a bit of copper pipe over tham and a mallet?

or start them off and fit the valve springs, will that push them on??

or is there a better way lol?


cheers

MAD EVO 4

Ive always tapped them on using a 10/11mm deep socket

Fudgey

iTrader: (4)

cool, thats good enough then, i aint got any copper pipe lol