Roosie

iTrader: (8)

are the xr4x4 bits same as 4x4 cosworth (sierra)

Engine Cradle
Gearbox
Steering Rack

155lee

iTrader: (10)

think the steering rack ends are 10mm longer each side,the bolt pattern on the bellhousing is different and im unsure about the cradle,but i think its the same.

natehall

iTrader: (2)

2.0 XR4x4 bellhousing is the same

Roosie

iTrader: (8)

its a 2.9 in question

155lee

iTrader: (10)

since there were very few of them compared to 2.9's i based my comment on that!

chaffe

gearbox ratios and first motion shaft are different also, front prop is different

tomoyb

iTrader: (3)

only the crossmember is the same

FletchCossie

iTrader: (4)

Roosie, I posted on your wanted thread. Look at my "Various updated 4x4 Cossie bits" post for most the bits you need

dojj

iTrader: (3)

you can use the crossmember, engine mounts, steering rack, props, diffs, rear shafts if you have the 2.9

if you have the 2.0 then you can use the gearbox, but not the diffs as they are different ratio's

Roosie

iTrader: (8)

i take it you can use front shafts of the 2.9?

dojj

iTrader: (3)

the front non cossie shafts are about an inch longer so they bind up in their stops

the cv's are the same though

Roosie

iTrader: (8)

so would be better as i have camber

snoopaloopa

iTrader: (3)

Quite a few people have fitted the longer xr shafts to lowered cossies due to the camber and problems when on full lock

xr4x4rs

iTrader: (5)

parts that are the same are

engine cradle
engine mounts
front and rear diff
rear driveshafts
front driveshafts are longer but will work fine
front and rear prop are the same(only early 2.9 and 2.8 used a skinny front prop)
rear beam will be ok, only difference is hubs are taller and bushes( fine if you go cossie hubs and poly bushes)
abs pump is the same