Manifold
#1
Part of the Furniture
Thread Starter
Join Date: May 2007
Location: North East, England
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
what will a four branch alone do to the standard engine? few bhp?
and will it help the cam im planning on putting in later?
thanks
and will it help the cam im planning on putting in later?
thanks
#2
Too many posts.. I need a life!!
![Default](https://passionford.com/forum/images/icons/icon1.gif)
What engine?
If it is a ZETEC there is no point as the standard manifold is good for 150 bhp. No point fitting cams to a ZETEC either as the standard cams are good for 170 bhp it is the inlet and mapping holding the engine back.
If it is a ZETEC there is no point as the standard manifold is good for 150 bhp. No point fitting cams to a ZETEC either as the standard cams are good for 170 bhp it is the inlet and mapping holding the engine back.
#4
20K+ Super Poster.
![Default](https://passionford.com/forum/images/icons/icon1.gif)
It will help more than you think, particularly mid range, as this will remove a step that ford put there for clean emissions, and will release some more grunt.
tabetha
tabetha
Thread
Thread Starter
Forum
Replies
Last Post
nicodinho
Ford Non RS / XR / ST parts for sale.
6
07-10-2015 12:56 PM
caprixpack
General Car Related Discussion.
0
25-09-2015 07:53 PM
wheelwizardrefurbs
Technical help Q & A
1
21-09-2015 06:42 AM
Si B
General Car Related Discussion.
2
12-09-2015 06:49 AM