Duratec engine into Mk1 Focus
#1
Virgin
Thread Starter
Duratec engine into Mk1 Focus
Has this been done? Been searching a lot but can’t find anything. I’m not talking about the ST170 engine or the Focus RS engine. I mean the Duratec engine from the Fiesta ST etc
#2
Too many posts.. I need a life!!
shouldnt be too hard as long as you swap the box to a proper mondeo/focus mtx as the bell housing pattern is different between the two mtxs
The following users liked this post:
Adamg1987 (28-02-2018)
#3
Virgin
Thread Starter
what mounts would work with the mk3 mondeo mtx box? or would it be a custom job? Ive tried looking at photos off the mounts on the internet but they look different.
#4
10K+ Poster!!
Probably just as easy to mod the mounts to make them work...bit of fabrication
Thread
Thread Starter
Forum
Replies
Last Post
xr-stu
General Car Related Discussion.
11
19-02-2014 11:29 AM
stevealien
General Car Related Discussion.
7
11-11-2011 09:25 AM
stevealien
General Car Related Discussion.
11
21-10-2011 06:04 PM
andy130
General Car Related Discussion.
3
13-02-2011 05:55 PM