I need help pls anyone!!! I'm going to do a head gasket on my car which comes as a whole set but I can't get a manual to guide me through it like taking parts off like cambelt etc so if anyone could help like a link to click on or anything pls post back 😀

 

Haynes manual mate

 

Good luck matey. I dont know if it will be easier taking the inlet manifold off with the head or take it off before you remove the head.

There isnt much room down there. I would take the exhaust manifold off and leave that on the car.

 

only manual covering the engine is the US version svt, asking for a how to on doing this would be like asking someone to write a novel

 

If you need chapter and verse instructions to do it, you shouldn't be doing it. It's just like every other zetec

 

Spot on as above

 

Right so peeps please help I've done the had gasket new plugs serviced etc etc.. It's all back together but runs lumpy on idle and it's all pointing to air n fuel now any suggestions please as I'm losing faith ����

 

try changing coil pack as one of the most common reasons for poor running on the 170

 

is the engine timed correctly

 

Probably not! Cam timing or a breather hose etc is left off.

 

All hoses are back on connected cams timed up as taken apart with like marks etc new coil pack done ??