5 stud conversion
#6
Hi,
Approach a local engineering company, it is not a hard job at all(engineering wise), they will most likely either just redrill 5 holes in pcd that you want, or weld your 4 holes, skim flat then redrill to 5 holes and tap, make sure you can get the offset you need before going ahead, I'm sure you can, but wouldn't want you to go ahead and find you couldn't.
Please pm me if you are in position for a sale please, thanks, would do these in gloss black for my mercury grey sapphy!!
tabetha
Approach a local engineering company, it is not a hard job at all(engineering wise), they will most likely either just redrill 5 holes in pcd that you want, or weld your 4 holes, skim flat then redrill to 5 holes and tap, make sure you can get the offset you need before going ahead, I'm sure you can, but wouldn't want you to go ahead and find you couldn't.
Please pm me if you are in position for a sale please, thanks, would do these in gloss black for my mercury grey sapphy!!
tabetha
Trending Topics
#8
#9
transit connect hubs, 5x108,job done!
or try here http://www.ezaccessory.com/Wheel_Ada.../4000-4000.htm
or try here http://www.ezaccessory.com/Wheel_Ada.../4000-4000.htm
Last edited by marky_g; 31-01-2010 at 07:25 AM.
#11
marky_g - you're sure Transit Connect hubs are plug&play - that would mean easy conversion both to 5x108 and to 300mm brakes at the same time (the same brakes as on ST170 as far as I rememnber)?
#12
I've found that life I needed.. It's HERE!!
iTrader: (1)
Joined: Feb 2008
Posts: 1,274
Likes: 2
From: Leicester
Use mondeo 300mm brake disks and calipers, will fit on your hubs unlike the ST170 ones that require ST170 hubs, almost identical the mondeo caliper is just slightly different. Interesting with regards to transit connect hubs, will the spline pattern match that on the ST170 drive shafts?
Thread
Thread Starter
Forum
Replies
Last Post
mk3ste
Restorations, Rebuilds & Projects.
19
17-10-2021 10:09 AM
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM