When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
ive got a fiesta turbo on ofac with a t3 on a bleed valve its wound right in but still seems to be boosting at a bar been told its the actuator ? any ideas
ive got a fiesta turbo on ofac with a t3 on a bleed valve its wound right in but still seems to be boosting at a bar been told its the actuator ? any ideas
Sounds like to much pre-load on the actuator, wind it OUT a few turns to see if boost lowers.
If not, pipe the turbo direct to the actuator (removing the bleed valve) and see what it makes, might be a leaking bleed valve.
I think he means if the 'vacuum' pipe that goes from turbo to bleed valve or bleed valve to actuator is split it will be bleeding off air all the time.
I think he means if the 'vacuum' pipe that goes from turbo to bleed valve or bleed valve to actuator is split it will be bleeding off air all the time.
Thats the ticket, I've once seen a DIY bleed valve plumbed into a Y piece between the plenum and the dump valve or dump valve and ecu, one or the other