rsmark86

iTrader: (3)

thinking of selling my inlet to free up some money to finish my rs......
i will use my efi one instead so if anyone is intrested give me a pm or call 07833022472

12_Second_rst

iTrader: (1)

Keep it just wait surely you don't need much to finish it

clarke5700

wanna sell the exaust manifold?

gus

iTrader: (1)

just to clarify thats not a fms inlet

was made by an engineer for tom scarlet

2 was made one for tom scarlets s1 and one for mk's xr2

still they worked well and im sure it will sell easily enough


good luck

rsmark86

iTrader: (3)

wicked gus thanks for the info its a realy good bit of kit.....

but i need the following to finish it....
plugs/leads/cap/rotor arm/ group a coil
044 fuel pump and fittings
anti roll bar bracket
fuel sender unit (in tank one)
a cam kit as its only got a piper285t and its no where near as wild as i want..
i want my dash flocking
trottle cable and bracket


then i need to get the car mapped aswel so just so much to do and im moving house so the car fund is very tight at the mo and im not selling up or breaking it....

martinmilne

would this fit efi head wat needs to be done to fit apart from pipe work to intercooler also wat aere the gains over standard pls

rsmark86

iTrader: (3)

yes it will fit a efi head as it is off a fiesta turbo engine and is fitted to my mfi head useing adaptor plate

rsmark86

iTrader: (3)

it will fit straight to a efi head and ive also got a adaptor plate to fit it to a mfi head it will make a conciderable difference as it creates a better flow rate and has been proven to run 350bhp on mk's old xr2 .... it will need a throttle cable bracket making to fit an efi cable and a 90 bend samco as its got a charge pipe made already...

if you are intrested give me a ring on 07833022472 after 9.30 tonight or all day friday onwards thanks