Hrsturbo

getting rid of the abs properly now and need to know how to re-plumb the brake lines, is there a braided line that can join pipes together or a sort of connector I can buy so I can run the pipes where I want?

Don't want to use second hand parts and want it to look good

cheers

Marc LJX

iTrader: (2)

When i did mine i just got some normal copper brake pipe and unions, and just made some little link pipes up. Wasnt too much hastle.

They werent too secure anymore though, so i had to fit a couple of brake pipe clips to the bottom of the bulkhead to stop the pipes flapping about (MOT tester made me do it)

Hrsturbo

Cheers! where can you get the pipe and unions from? Halfords?

SafeChav

Any motor factors mate.

The pipes only need to be about 7-8 inches long (if that)

Its very minimal patching work

Chris69

have just done this and tbh its minimal wrk but u do need a decent motorfactors, not an off the shelf place like halfords
gotta secure my new pipework for me MOT due soon but should look stock as the pipes run quite simply when using existing pipework, and a non abs resorvoir

SafeChav

And what would you know about decent factors Mr Cunt?

£5 a box for latex gloves?

Those shocking HT leads they sold you?