got one for my car at ford fair and just getting round to fit it just wanted to know if any one had fitted one and what did they use to stick it on as mine fits well but it will need holding in place while the glue goes off because where the slot in the rear bumper runs mine doesnt fit very well there unless you push it and hold it

Dont know if i like it or not, but as my bumper has been melted by the exhaust it needs something to cover it and as this will match the front splitter i hope it will grow on me, because once glued on it will make a mess to remove it

any ideas cheers dunc

 

i used wurth bond and seal wedged wood from floor to car left over nite to dry

 

Rivets m8.

Undo the back bumper, rivet it in place with some blacks rivets and once installed again, you won't notice it because of the exhaust.

 

sounds like a good plan speedy G only problem i have with that is my exhaust has melted most of that part of the bumper away

 

Could try silicone... though the heat may melt it off??

 

Geert,

Any pic's of your on yet.................Got to get round to fitting mine soon i suppose!

 

heavy duty bonding WILL hold it!!!!

 

Euhm, haven't had the time to fit it yet.