I bought a 330bhp conversion for my Escort Cos. but I am not sure how to fit it. I have NOT been looking inside the ecu, but at this point I am already think, what I am going to do with the 2 chips that is in the little box from Collins. In the box are a chip all alone., and a chip on a little printboard.

When I open the ecu, will it then be very clear where to fit these chips?

 

yes it will. the collins chip has a babyboard, forget about it, and just plug the chip who is "alone" in the chip socket.

 

Why forget about this babyboard, when it came with the kit?? are there NO info in it that is needed for the conversion?

There are no instruction with the kit, so what about boostpressure and so?

Fitting of map and greens are already done! Just need to fit the chip(chips.

 

The Collins board is needed as it's an encryption board - the board plugs into the std chip holder, and the Collins chip into the board.

If in doubt, give them a ring.

 

Oki and THANKS!!!

 

How much boost is it adviseable to adjust it to??