Hello guys and merry Christmas !🎁 🎄
After a long time i decide to upgrade my t34 of my little powered YB to a newer one so i find a bargain of a gtx3076R 0.64 gen1 with billet compressor wheel and fully rebuilt.
I would like to know what parts will i want to be ready on this setup.
I am aiming around 450bhp+-
My YB came from a late 205 4wd sapphire setup and now runs on these

-Fully forced engine except rods//full set of cometic and Arps
-4wd head with new valves
-Newman 256/350 inlet cam and alloy pulleys
-High pressure oil pump
-2wd exhaust manifold
-3" exhaust
-Tial extenal w/g 38
-spacer on the inlet manifold
-4x Bosch ev14 630cc
-Bosch 044 fuel pump
-Aeromotive fuel pressure regulator
-Standard fuel lines
-Alloy radiator and rs500 cooler
-New engine loom and a stand alone Ecu with coils on plug

So what's the next step?
Any updates to fuel lines? Any bigger fuel injectors?
Sorry for the long post and my bad English ☺️

TIA and happy new year to everyone!

 

Hi,
Your engine block is 205?

 

Hey! Yes its a yb 205 block with the double two on the side. Im not looking for extreme power.
I know two guys who run 2876 and 3582 gen2 and hold almost 30 psi on a std 205 without issues for some years