Here are the results,does it sound right for msd 380 chip

383.2bhp@4685rpm
450.7ibft@4305

 

is that right 383 at 4685rpm what did it make at 6500rpm?

 

.

 

Peak power at 4600rpm? You sure it had grip?

 

Yeah it was gripping....it sounded like it was hitting the limiter.it never made 6500

 

 

it was holding boost too,somethings not right to me ?

 

What rollers mate?

 

That doesn't seem right at all mate to me

 

so does that say the afr was 13.5 at 3800 rpm?

 

yep

 

how can you get such a sudden spike,could that be a misfire

 

if its right, its good going for a .48!

 

i dont know, but i strongly suggest you take it to somebody who knows what they are doing and get it set up properly,before you melt the engine.

 

mmmm that doesnt look right at all, get it checked and set up somewhere mate. a cosworth specialist preferably.

 

Think i'm gonna take a trip to reylands,2nd opinion,it sounded like to me it was hitting the limiter on the rollers,if it was slipping ,surely the bhp would not be so high,He had to do it in 5th gear,as 4th went to quick,about 2 seconds it was all over

 

it wasnt set up on the rollers correctly then mate as ive had 2 high power rwd cars on rollers one at 472 bhp and one at 550 bhp and both were run in 4th and both took longer than 2 seconds from hitting boost to the limiter.

i have seen that happen with the 472 bhp one but it was due to wheelspin and had to be strapped down tighter.

 

That ain't right at all

What RR did you use ?

Steve

 

just trying to upload the video,,its like he has set the rpm wrong(ground zero)if you know what i mean

 

Racepower motorsport

 

Never heard of them

Steve

 

video
http://www.youtube.com/watch?v=135FJj_iHHg

 

doesnt sound right atall mate.

 

omg whoever he is hes a herbert !!! lol

take it somewhere else mate they aint got a clue

 

As above mate somewhere else where they don't employ kwik-fit staff to operate rolling roads.

 

Another vid
http://www.youtube.com/watch?v=2hQ8C5usuSo

 

that one seems abit better

this was mine nigh on 500 bhp aswell


http://www.youtube.com/watch?v=dIDlPMo-nFQ

 

the plug gap was set to .50,this seemed to cure the misfire,but would i lose out higher up ?

 

what ecu are you using?

plenty of capable people around your way!! (assuming your still in Kent)

 

450lb ft torque ?? lol ! i wouldnt even bother with them rollers bud take them to a decent well known place ask them to set it up and get a power run

 

Sadly with those recorded figures you may as well throw the whole graph in the bin as its garbage from start to finish. sorry mate.

 

why not take it to msd?

i would if i had their chip in my car.

 

they won't take the car out on the road