Help needed guys and girls

Is there anyone near blackpool who could give me a hand with removing my wheel airbag?

I have been struggling with it all day and I know it will be a two minute job for someone who has done one before.

I will happily give some beer money for your time

Si

 

i live in blackpool never removed one of a feista done some mondeo ones if out like them its 2-4 torq screws accessed from the back of the wheel once undone its a clip on the detonator as you remove airbag

 

There are two springs you have to prise open.

I have had me, my dad, a mate and even my misses trying it today but to no luck as I am trying to fit a flocked dash. Everyone I talk to who has done it says it is quite easy as well but Im sure that is to wind me up lol

 

lol where abouts in blackpool are you

 

Thornton Cleveleys near norcross roundabout

 

lol near my brothers lol

 

All sorted - thanks alot Taz for your help mate - it was very much appreciated

Top bloke!

 

Ah so it was you that Scott was asking for help for. I tried to describe it best I could through my laptop.

 

Lol yeah - I never got your paint diagram lol

 

pretty crap design so much easier with the two 5.5mm bolts,

 

Yep good to see Ford have got worse over time

 

no prob si like i said anytime good to meet you today

don't think you was far off though it was just perseverance mate and luck getting it in right position lol

 

I hated this when mine was done! I even drove my car 15 miles to get it done by Tim (aquarious RS) I was always thinking this is gonna go in a minute!!

BOOM!!!!!

 

Alan, how long did it take me to do yours? Can get the whole wheel off in less than 5mins I reckon. Takes all day the 1st time then after that it's a piece of piss

 

well took me about 20 mins or so as that was my first one not bad me thinks lol

 

Hi i have the same problem, i am wanting to get the steering wheel off and there are two holes where you stick a screw driver in, tried everything but no joy, is there a way to get these off, tried the manual, does not say how big the screw diver or anything, i am at Warton nr Blackpool, thanks Ian