Hi everybody, just done alot of work on my car and its gonna go to APT for set up and rolling road hopefully next week, but just wanted a rough estimate on the power i should expect,

STAGE 3 polished ported head with kent cam, vernier, double valve springs, stainless lifters etc, stage 3 turbo, -34, pro alloy front mount and rad, full mongoose, k&n, switchable boost chip, running 18psi. oh and stage 1 fast road clutch.

Any rough estimates would be great, many thanks

 

160-170@Wheels.

 

170-180 @ wheels would be my guess

 

so how much does that work out at the flywheel?

 

200 ish.

 

About the same

 

180bhp @ the wheels at least imo

 

Its got the bits you need

STAGE 3 polished ported head
kent cam
vernier
double valve springs, stainless lifters etc
stage 3 turbo
-34
pro alloy front mount and rad
full mongoose
k&n
switchable boost chip
running 18psi
stage 1 fast road clutch.

I would recon it wouldnt be far off 190 ATW

(i know i agreed with Christian earlier)

But going with this other car last week with

spec is all low comp pistons, kent cam, stage 3 turbo, stage three head, cossie fule pump, organic clutch, B&M short shift, ram air filter, breathers, swirl pots, loads to be honest!

It made 188.6 BHP @ 18psi! and 205 pound of torque

So it will probably be a similar figure coz i think its the same type of rolling road.

 

Apparently it could be as much as 300bhp @ Wheels