tryin to get some injectors from the states for my cossie. the resistance on them is 2.8 ohms just wonderin if this will work on my cossie? oh and there 72 lb injectors..... think this is around 750cc but maybe somone can enlighten me thanks

 

Easiest thing to do is this...

Get a multimeter and set it to ohms.
Unclip one of your injector plugs and put the 2 multimeter leads on the 2 terminals.
Take a reading.

It should be around the same give or take a few ohms...

 

2.8 ohms should work fine on Cossie management.

 

yup, 750cc ish

 

thanks for the replies lads .... anyone know if these will work with an omex 600 unit

 

I suspect you may need to use ballast resistors with them on omex.

 

does the omex support high or low ohm injectors??