Originally Posted by
peteh
ooo ill be watching this like a hawk, what master cylinder did you use?
i used this one from burtons,im not 100% sure its the correct one to use but at least i can go up or down on the bore size if i need to,wont find out untill its all back together.
http://www.ebay.co.uk/itm/1506255185...84.m1439.l2649
Originally Posted by
Jack and the Beanstalk
I am also intrigued on this hydraulic clutch mod, I wanna do the same to mine, but im not 100% sure how to do it.
I saw on earlier pics of what appears to be some hydraulic fitting at the back of the clutch bearing on the drive shaft. Is this part of the mod as well?
Awsome job on the restoration so far. Looks flippen brilliant. Keep on going.
yes the centre push bearing in the gearbox is part of the mod too.
if you want to do a hydraulic conversion on your car you could buy a similar kit from martin at reyland.