Originally Posted by
Christian and Beccy
Chip, if I said I had built my engine but had only discussed tightening the main bearing caps up, would that suggest that I left the big-ends loose?
Not unless you posted something to imply that you didnt understand they needed to be tightened
There is an awful lot of pre-calibration that happens before the car even goes near the dyno (or the road, in that case). It's not relevant to a discussion about road vs dyno mapping. Is it?
Such as that, im not talking about pre-calibration, and the very fact that you think I am implies you really havent got a clue how to map a car on a low resolution ECU, as the whole point of what I am saying is that you CANNOT do this without driving the car, if you dont know why, then you obviously dont know very much about road mapping!