Pf09 tps
#1
I've found that life I needed.. It's HERE!!
Thread Starter
Pf09 tps
Hello could someone explain to me the correct way of setting up pf09 tps sensor as mines not set up correctly
Thanks mark
Thanks mark
#2
PassionFord Post Whore!!
iTrader: (4)
Volt meter set to 20v
Then black probe on pin 17 and red on pin 11, voltage should be 0.23v with ignition on engine not running.
Slacken off the 2 screws holding the tps to the throttle body and turn it in whatever direction you need to get to 0.23v then nip up the screws.
Then black probe on pin 17 and red on pin 11, voltage should be 0.23v with ignition on engine not running.
Slacken off the 2 screws holding the tps to the throttle body and turn it in whatever direction you need to get to 0.23v then nip up the screws.
Last edited by Cossy Mike; 21-09-2014 at 08:34 PM.
#3
I've found that life I needed.. It's HERE!!
Thread Starter
Volt meter set to 20v
Then black probe on pin 17 and red on pin 11, voltage should be 0.23v with ignition on engine not running.
Slacken off the 2 screws holding the tps to the throttle body and turn it in whatever direction you need to get to 0.23v then nip up the screws.
Then black probe on pin 17 and red on pin 11, voltage should be 0.23v with ignition on engine not running.
Slacken off the 2 screws holding the tps to the throttle body and turn it in whatever direction you need to get to 0.23v then nip up the screws.
Mark
Thread
Thread Starter
Forum
Replies
Last Post
DixieTheKid
Ford Sierra/Sapphire/RS500 Cosworth
11
06-06-2020 11:20 AM
kosienutter
General Car Related Discussion.
31
22-08-2015 09:55 AM