99 turkish 200 block
#1
Part of the Furniture
Thread Starter
99 turkish 200 block
ive got a new 99 turkish block. going to be putting a t38 on it.
i suppose bhp will be 400 ish
would you use the block??
thanks
i suppose bhp will be 400 ish
would you use the block??
thanks
#4
Too many posts.. I need a life!!
iTrader: (2)
makes me laugh when people refer to blocks as 'Turkish'
Seen as every block was cast in Turkey then sent to Germany for machining does that mean we all have something to worry about?
There was however a batch that were miss cast leaving the bores of centre by around 5mm most of which were destroyed with only about 50 or so slipping through the net!!!
If your un lucky enough to have one of those forget about 400bhp
Seen as every block was cast in Turkey then sent to Germany for machining does that mean we all have something to worry about?
There was however a batch that were miss cast leaving the bores of centre by around 5mm most of which were destroyed with only about 50 or so slipping through the net!!!
If your un lucky enough to have one of those forget about 400bhp
#6
Happily retired
makes me laugh when people refer to blocks as 'Turkish'
Seen as every block was cast in Turkey then sent to Germany for machining does that mean we all have something to worry about?
There was however a batch that were miss cast leaving the bores of centre by around 5mm most of which were destroyed with only about 50 or so slipping through the net!!!
If your un lucky enough to have one of those forget about 400bhp
Seen as every block was cast in Turkey then sent to Germany for machining does that mean we all have something to worry about?
There was however a batch that were miss cast leaving the bores of centre by around 5mm most of which were destroyed with only about 50 or so slipping through the net!!!
If your un lucky enough to have one of those forget about 400bhp
The ones with '99' cast into them are the batch that can cause problems. Their ARE loads of those around & at 500bhp its perfectly fine. At high 600's a new 99 block have been found to warp. I know cos i measured mine . MADAde has a 99 block used at low power & fully heat cycled that is currently OK at 650bhp.
#7
Too many posts.. I need a life!!
iTrader: (2)
No!! only a single batch are causing problems
The ones with '99' cast into them are the batch that can cause problems. Their ARE loads of those around & at 500bhp its perfectly fine. At high 600's a new 99 block have been found to warp. I know cos i measured mine . MADAde has a 99 block used at low power & fully heat cycled that is currently OK at 650bhp.
The ones with '99' cast into them are the batch that can cause problems. Their ARE loads of those around & at 500bhp its perfectly fine. At high 600's a new 99 block have been found to warp. I know cos i measured mine . MADAde has a 99 block used at low power & fully heat cycled that is currently OK at 650bhp.
and why do people refer to them as Turkish?
Trending Topics
#8
Regular Contributor
What's the limit with this '99-block?
I have '99-block (90.5mm bore) with original head bolts and it has dynoed 608.4hp@8098rpm / 593.4Nm@6803rpm.
If I lower the power to approx 500hp and increase torque, does it hold together?
I have '99-block (90.5mm bore) with original head bolts and it has dynoed 608.4hp@8098rpm / 593.4Nm@6803rpm.
If I lower the power to approx 500hp and increase torque, does it hold together?
Last edited by Jasu; 02-04-2012 at 10:30 AM.
Thread
Thread Starter
Forum
Replies
Last Post