Ok so heres the situation...
I got Stage 3 bits (K&N, Stainless exhaust, Greens, 3 Bar MAP)
Ported head
500 intercooler
T34 comming very soon

Question is, will the stage 3 chip be up to the job with this lot?
Im guessing that it will have to be on the rollers again because of the T34. But, will it need a live map?

Cheers Peeps!

 

no, just get a set up done on the rollers and it will be fine

 

mine runs fine on the same spec and its "only" got an AVA stage three chip!

 

it should be fine but anything over 20psi on a t34 the chip will most likely be flat out on fuelling at maximum revs definitely get it mapped to be safe.

 

Ta for the input peeps!
Got a clutch going in on thursday, then a T34 to order and then a session on the rollers.....Money bloody money!