Hi all bought a sapphire cosworth shell and decided to fit a 24 v in it with xr4x4 running gear, having a nightmare getting it started even after pouring over the tinternet for hours !! Ive got the following on it, any advice gratefully received!!engine is cranking, ive got a spark, pin 8 on edis has 12v all injectors have 12v ,coil pack has 12 v ecu is priming fuel pump on initially and when cranking, have fuel up fuel rail, maf has 12 v , pin 37 and 57 on ecu is switched live, pin 1 is perm live,ecu pins 20 40 and 60 are ground, have checked injector plugs for continuity but not hearing initial click from injectors or anything from that area , any ideas ,im ready to push this into the nearest canal its getting on my nerves now 😡

 

EARTH ?

 

edis 6 , coil pack, and ecu earthed and ecu pulsing earth to injectors as they have a permanent 12 volt and the ecu switches the earth to the injectors.

 

cps failure?

 

Ive been told that because im getting a spark the crank position sensor must be ok, going to spray some easy start in intake to see if it runs on that

 

and the plug leads are on the correct plugs yes?