Hello Everyone.

Can anyone send me a wiring diagram of the OFAB loom? I need to know exactly what pin goes where from both the ECU plug and the EDIS module!!

Also i need to know what the hell does the Yellow with Green trace wire go to coming out of pin 2 on the EDIS? It also has been cut.

If someone can come up trumps with an exact wiring diagram to help me work out and make sure every pin is in the correct place on both the ECU and EDIS so i can re wire it to what i need it to do.

Thanks

 

have a look on rsbible, if not pm a email address and i email a few diagrams over

 

Ive looked on there fella and its confusing. all im after at the moment is a correct wiring diagram of and OFAB loom so that my mate can trace every pin from both the EDIS & ECU and make sure they are joined to there correct sensors etc.

To cut a long story short i brought a OFAB loom & ecu off my mate as ive converted my ERST to EFI and before we splice the EFI loom into my loom i want to to check to make sure every pin is correct and the colour of the wires match up with the correct pin so that they run correctly.

Probably abit confusing mate i do apologise lol.

 

Anyway mate PM sent with my email address. Thanks pal

 

This MIGHT help http://www.fiestaturbo.com/forums/gu...8628/#p1760443

 

sent you some info