Evening guys,

To ensure I have the correct connections in the right place, can you guys help with the identification?

1: End of the loom - Distributor, PF08, Idle Valve, Knock Sensor or spare


2: Middle of the loom - Water Temp Sensor, Oil Pressure Sensor, ???


3: Middle of the loom - ????


4: Top of the loom - ????


5: Top of loom - ????


6: Top of loom - Ignition Module????


7: Top of loom - MAP Sensor????


8: Top of loom - ????


9: Top of loom - ????


10: Top of loom - ????

 

Anyone help?

 

no 10. diagnosic plug i think
9 . amal valve
8. coil
4. 02 sensor

 

ogg the top of my head i don't know what 3 or 5 is the rest you have identified

 

Any takers for 3 & 5?

 

did the car have air con that it came off? to could be to do with that

 

Not sure, I'll need to pm th chap I bought i off. Thanks

How does it connect to the fuse box or power?

 

5 is the connection for the engine loom to the car, num 3 i think is the lambda sensor wire.

 

Cheers herb. I'm not running a lambda so will just tie it to the side.

Is the ignition amp for a 2wd different than a 4x4?

 

i dont think there different mate

 

the loom used to be mine and i bought it off Paul Ripley who i assume had it off an escos.

No idea if it ran air con or not - sorry

 

If you can pin it out and tell me where the pins go back to on the main ecu connector then i will be able to tell you what they are for

 

Number 3 is canistervalve ?

 

Whats the canister valve? Where is it located?

 

it was on escorts i belive

 

I found a diagram so sorted now cheers