stress317

I own a series 2 Orion, which I am now starting to restore and it needs wings however i prefer the series one front end, can anybody tell me if I bought series one front panel, slam panel bonnet and wings it'd all fit the series 2 shell?

Thanks

AstoN_B

iTrader: (1)

Dont quote me on this but it's pretty likely. Ive seen a few escorts that have been converted from Mk4 to Mk3 using the bits you mentioned.

You could check the Hadrian panels website and see if the inner wings etc are the same panel part numbers.

stress317

Thanks mate ill give it a look

phil_rs

iTrader: (3)

Cross member is needed too which will mean you need a mk3 roll bar setup which ain't a bad thing.

Here's my old mk4 converted van

stress317

Thanks mate, so I need the mk3 tie bars and cross member as well? Mines been hit at some point by previous owner and i think the series one fronts the way to go, got all 2.0 zetec on carbs aswell. the van looks well smart mate

1.9 xr2 on 40's

https://passionford.com/forum/restor...5-12-07-a.html

phil_rs

iTrader: (3)

Cheers mate, sold it a while back now.