ecu help
#1
Virgin
Thread Starter
Join Date: Oct 2010
Location: North London
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
ecu help
Hi guys
Can any one help with this iv got a l6 ecu and have just installed a lambda sensor can I connect the single out to pin 2 to create a closed loop circuit
Thanks mike
Can any one help with this iv got a l6 ecu and have just installed a lambda sensor can I connect the single out to pin 2 to create a closed loop circuit
Thanks mike
#2
I've found that life I needed.. It's HERE!!
No. Software inside the L6 does not recognize the lambda signal and is not capable of maintaining a closed loop situation. That is if the hardware is present to measure the lambda signal, which I doubt.
For closed loop you need a L8 or P8.
For closed loop you need a L8 or P8.
Thread
Thread Starter
Forum
Replies
Last Post
DixieTheKid
Ford Sierra/Sapphire/RS500 Cosworth
2
14-09-2015 09:04 PM