im just putting bk my cv joints togehter an on the drive shaft im up to the point on putting the spring washer on then the cv joint on then the circlip i was just wonderin should there be movement between these to circlips or none at all as i have 3 that dont move an one that has a bit of movement

 

i think you have answered your own question there mate!

 

well iv too the shafts an cv of my 3 dr and the shafts an cv of me 2wd saph iv used the 3dr shafts which had spring washers an iv used the best of the cv joints but the 2wd cv didnt have any spring washers in the cv joints but the 3dr ones did

 

Any help wond be greatfull i need yo get me shafts built up thanks