Priming Hydraulic lifters.
Thread Starter
Wahay!! I've lost my Virginity!!
Joined: Jun 2010
Posts: 59
Likes: 0
From: Derry
Priming Hydraulic lifters.
Hi. sorry if this has been covered before...
I'm near ready for a dry fit clearance test on my high lift NA Cosworth
My lifters are hydraulic and when removed I squeezed the oil dirty oil out, they are now squidgy and I'll be getting a wrong reading in the dry fit.
I tried to prime them but they wont firm up, all air squeezed out and pumped submersed in oil the right way up, still squidgy?
(2 of) Been in oil 2 days.
Any advice peeps?
Thanks
I'm near ready for a dry fit clearance test on my high lift NA Cosworth
My lifters are hydraulic and when removed I squeezed the oil dirty oil out, they are now squidgy and I'll be getting a wrong reading in the dry fit.
I tried to prime them but they wont firm up, all air squeezed out and pumped submersed in oil the right way up, still squidgy?
(2 of) Been in oil 2 days.
Any advice peeps?
Thanks
Last edited by Craigorypeck; Sep 12, 2010 at 05:05 PM.
Thread
Thread Starter
Forum
Replies
Last Post
PRO-LINE MOTORSPORT
General Car Related Discussion.
5
Sep 28, 2015 09:54 PM
wheelwizardrefurbs
Technical help Q & A
16
Sep 23, 2015 09:21 PM
wheelwizardrefurbs
Technical help Q & A
8
Sep 18, 2015 08:59 PM
