Technical help Q & A Got A technical problem with you car? Keep it in here where the techies hang out and we will try to solve it for you!!

Mondeo ST TDCI

Thread Tools
 
Search this Thread
 
Old Aug 16, 2010 | 07:14 PM
  #1  
deeksy33's Avatar
deeksy33
Thread Starter
Virgin
 
Joined: Aug 2010
Posts: 3
Likes: 0
From: cb1
Default Mondeo ST TDCI

Hi all,
I've recently bought a 54 plate st tdci. On the whole it's ok, but I have two problems!
1) I have no power to the reverse lights. The fuse is ok?
2) At just over 1000rpm, and from start up, if I rev the engine too slowly, the whole car judders as if the engine mounts are soft, and it takes a short time to rev cleanly?
Any help/ ideas would be greatly appreciated
Reply
Old Aug 16, 2010 | 07:40 PM
  #2  
Dal_'s Avatar
Dal_
PassionFord Post Troll
15 Year Member
Liked
Loved
Community Favorite
iTrader: (2)
 
Joined: Nov 2006
Posts: 2,553
Likes: 65
From: Northants
Default

1. Fuse 80 in the central Fuse box is for the reversing lights. (Well it is on my 56 plate ST TDCi)
2. Might be your crank pulley / aux belt which is common to go. Or if it's not that, the dreaded Dual Mass Flywheel.
Reply
Old Aug 17, 2010 | 10:15 AM
  #3  
deeksy33's Avatar
deeksy33
Thread Starter
Virgin
 
Joined: Aug 2010
Posts: 3
Likes: 0
From: cb1
Default

Thanks guys, I think I'll bite the bullet and make the long drive up to Newark. The car is still in warranty, so they can deal with it. They said it had been checked and serviced! I can't see that with the faults I've fixed so far, and the bigger faults I won't tackle, plus the old air filter etc.
Is there anything I should look out for that might crop up in the future? Is it a good/bad idea to chip tune it?
Thanks, Jay
Reply
Old Aug 18, 2010 | 04:53 PM
  #4  
martysmartie's Avatar
martysmartie
PassionFord Post Whore!!
iTrader: (1)
 
Joined: Dec 2007
Posts: 8,460
Likes: 103
Default

I would think it's the reversing light switch at fault.

I know on the Mondeo Diesels the injector's and the said DMF are rife for problems so as you say best of taking it back to dealer especially if you just brought it it's there problem.

Martin
Reply
Old Aug 23, 2010 | 03:44 PM
  #5  
deeksy33's Avatar
deeksy33
Thread Starter
Virgin
 
Joined: Aug 2010
Posts: 3
Likes: 0
From: cb1
Default

Hey mate, Jay here.
I see that you have a 56 plate ST TDCI, have you changed the engine output at all?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mark94
Ford Mondeo Including ST
5
Oct 10, 2023 06:52 PM
wowk
General Car Related Discussion.
4
Mar 30, 2021 07:49 PM
Brickhouse
General Car Related Discussion.
14
Oct 3, 2015 07:28 PM
The Enigma
General Car Related Discussion.
6
Sep 29, 2015 10:31 AM
Sp3no
Technical help Q & A
1
Sep 27, 2015 07:23 PM




All times are GMT. The time now is 01:37 PM.