i have seen a couple of featured cars(erst) withmtx75 gear boxs i have managed to accquire one but it is not as straight forward an operation as i first thought i spoke to jano whom informed me that i'd need s1 anti roll bar custom drive shafts custom mounting brackets etc, etc...basically told me £1500 for conversion...as i stay way up north i.e past aberdeen i was wondering if any one out there could make/source bits required for conversion barring the gear box...any one with any info could you please pm myself thanxs..

 

 

Been looking for a few past post's about the MTX75 and equal length shafts

https://passionford.com/forum/viewtopic.php?t=92553

https://passionford.com/forum/viewtopic.php?t=92213

https://passionford.com/forum/viewtopic.php?t=92544

https://passionford.com/forum/viewtopic.php?t=93416


Hope this helps
Regards
Jano