Hi all,

i want find some pictures to the water injection system (I.S.S.) fitted on the 2500 first Escos produced.

(Intercooler Spray System)

have you got a good plan?

kind regards

Pascal.

 

The system was not fitted. All they did was put a rubber bag in the boot with a note saying DO NOT CONNECT! It also needed a change to the ecu's software, which was not supplied by Ford for sale to the general public.

 

OK, anyone have got some information about this?

in my car (Escos T35 luxury october 1992), the small tube was connected on the exit of the intercooler. it's running up side the fuse box, after, i lose her trace...

i search any pictures about the water bag

thank for all

 

http://www.siipicossu.com/manuaaleja/groupamanual.pdf
See page 24 for drawings of the complete system on a Group A.
The connection to the ecu is assuming you use a Group A Eprom.

http://www.siipicossu.com/manuaaleja...20Part%202.pdf
See page 6. This is the group N drawing.

 

I have it in my car. High pressure pump under back seat, bag in the boot, and injector in oe ic. I have never try to connect it, mine secs monitor could drive it, but now i have another ic whitout the injector

 

Thank for answer GRCOSSIE,
if it's possible, can you take a lot of pictures about water bag and the pump?

where going the small tube after the fuse box? where it pass away?

thanks for all.
Pascal.

 

I shall try to get some pictures to you when i get back to my car. It was a new bag on ebay for some time ago. I think the pipe goes near a pillar and under floor carpet