Does anyone have a pic of a plenum on a 2wd saph. There is a pipe missing from mine and its just sucking air in which is making rev to 2000 rpm and when i put my finger on the hole where tha pipe is meant to be it idles like new. So i need a pic of plenum and all pipeing if anyone has it. Cheers

 

Think 1 goes to map sensor then 1 to fuel press reg and 1 to ya dump valve, so follow pipes from these and see where they lead.
Hope its not ya map or reg pipes not on as that can fuck ya car up.
Good luck cheers steve

 

Thanks Steve, ill check all theses.
Cheers.

 

Nearest front stud to dump valve(atmo or recirc), middle one to MAP sensor, this has two 90 degree bends a the bottom so that fuel vapour can't run in, rearmost stub to fuel pressure regulator, this is how mine is anyway.
tabetha

 

Cheers folks