lumpy tick over
12-07-2008, 05:40 PM
#1
Wahay!! I've lost my Virginity!!
Thread Starter
Join Date: May 2006
Location: merseyside
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
lumpy tick over
when starting my cossie it is very irratic on tick over until it reaches running temperature
could it be time for a new set of plugs or are there any common faults that cause this?
could it be time for a new set of plugs or are there any common faults that cause this?
12-07-2008, 05:47 PM
#2
I've found that life I needed.. It's HERE!!
Join Date: May 2004
Location: bucks
Posts: 1,054
Likes: 0
Received 0 Likes
on
0 Posts
Could be the plugs or maybe try a new idel control valve , mines abit lumpy for a few secs when its cold next time you start it from cold disconnect the icv if its the cause of the problem it should tick over at about 700 rpm smoothly....
12-07-2008, 06:57 PM
#5
I've found that life I needed.. It's HERE!!
Join Date: May 2004
Location: bucks
Posts: 1,054
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
