Hi all, has anyone ever fitted a Garret T28 from a Nissan Skyline GTR to an RST engine...the reason I ask is that I have a 89 RST Cabriolet in my garage that has a duff turbo....but I also have 2 RB26 turbos from my skyline sitting on my shelf....Ive had a look and although the T28 seems bigger, the exhaust side looks like it will fit the manifold, I may have to rotate the housings to match (is it just a case of loosening the bolts and turning it?) and I will have to make up an adaptor for the inlet pipe to fit onto the inlet housing......is this possible or am I speaking ga ga??

Big thanks for any help
Jay

 

Anyone done/seen this done before or got any advice??

 

all things are poss m8 !!

ive used similar unit on a cossie , T28 core based model ( esc cos small housing ) and GTIR comp house and wheel , was a very very good setup for low speed performance and top end !! was good for 2 bar boost

 

Cheers buddy, Im going to get the old unit off and have a go anyhow
Jay