Spiky

iTrader: (1)

ok, my mate just bought a escort cossie

it's running l6,

was running ok, then stalled now wont start, the fuel pumps stopped priming, so he run a constant live to them, still nothing

now he's found out there's no spark

but last night he went out in the garage and it was sparking, but couldn't try to start as the battery was flat

now today he's gone to look again and there's no spark.

any ideas???

would this be an ECU fault??

or a sensor? like the phase sensor or crank???

any help greatly appreciated

silky16v

iTrader: (1)

try pahse connector & check condition also look in the loom plug and make sure wires still in the plastic casing also check crank sensor

dave cos4x4

iTrader: (5)

ecu problem imo.

try another one with another chip if you can.

Spiky

iTrader: (1)

ok will let him know so he can try tomorrow

Turbo Zetec

iTrader: (1)

i had a similar problem, turned out to be a pin not pushed in far enough on my ignition module

Chip

iTrader: (3)

If the phase sensor is knackered it will run without one (not well ,but it will run) if you just unplug it, so thats easy to rule out.

Spiky

iTrader: (1)

ok will get hime to try that too

tabetha

No prime and no spark look at CPS first,
tabetha