Cam Change Problem...
#1
Part of the Furniture
Thread Starter
Join Date: May 2007
Location: North East, England
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
Cam Change Problem...
ive changed my standard cam to a piper 285 in my mk2 xr2 and cant get the pulley on the end of the cam, i was putting the standard one on while i got a vernier pulley, i got to the point where i was hammering it to try and persuade it.
are the shafts different diameters?
thanks
are the shafts different diameters?
thanks
#3
Too many posts.. I need a life!!
Join Date: Sep 2007
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
also if it dont fit FFS dont force it too much, if need be you will have to get another one. its better to get another than risking damagint the actual camshaft with male rage
can you possibly send some photos?
can you possibly send some photos?
#4
Part of the Furniture
Thread Starter
Join Date: May 2007
Location: North East, England
Posts: 161
Likes: 0
Received 0 Likes
on
0 Posts
i tried with the woodruff key out and it was still no go!
ive just ordered a vernier pulley so i dont have to force it, it was bad enough hammering the old cam out lol, i think i was abit too rough looking back, all good though!
ive just ordered a vernier pulley so i dont have to force it, it was bad enough hammering the old cam out lol, i think i was abit too rough looking back, all good though!
Thread
Thread Starter
Forum
Replies
Last Post
CrOwSoN15
General Car Related Discussion.
2
14-09-2015 11:33 AM