Hi,
Does anyone know the pinouts on a sierra cosworth ignition module.
Im actually stuck with the 2 wires that go to the ecu(pin 24+25). I know 1 must be a trigger wire but i cant figure out what the second one is for?

Anyone have any ideas? Im putting a motec ecu into my 4x4 saph and hopefully this is the last complication before its running again

Thanks
John

 

1 output to coil
2 gnd (0v)
3 trigger gnd from ecu
4 pos (12v)
5 not connected
6 trigger pos from ecu
7 not connected

 

http://www.motec.com.au/drawings/m11.pdf