can anyone give me the oem part numbers to a few sensors?
MAP
Mass Air Flow
TPS
Camshaft Position
Temp

 

 

for what car?

if its a cossie - DONT bother getting themfrom ford - they will cost literally 5 times more than they actually are.

they are not ford parts, they are all magnetti marelli, most of the traders on here stock and sell them for a fraction of the cost of ford,

 

i need them for a sierra cosworth

 

ok guys i truley need some help with this, i need the oem part numbers to a sierra cosworth, i live in the US and i dont have anyway to find these out so any help would be very nice.

 

FINIS codes for them all

water temp senssor for ecu :1639283
air charge temp sensor for ecu: 1639284
TDC sensor on bottom pulley :1639282
2 bar map sensor:1638311
TPS sensor(2wd): 1639312
TPS sensor (4wd):6909241
water temp sensor for dash board :6145143
ignition amp: 1637546


hth

 

ithere uis no mass air flow sensor,,, it relies purely on MAP,

and the phase sensor is not listed as a sperate item, only a complete distributor ?!?

you would best be getting al of these parts form over here and having them shipped to you....

seriously, the price of a £20 sensor from a specialist is literally £100+ from ford

 

thanks for the help, these are the oem numbers and not aftermarket numbers right?

 

yep, the FORD part numbers

 

but here are some of the sensors own part numbers as refered to by the manufacturer - Magnetti Marelli.

air charge sensor : ATS04
coolant temp sensor: WTS05
crank/TDC sensor: SEN8D
4x4 TPS: PF09
2wd TPS: PF01
2 bar map sensor: APS02/03

 

Magnetti Marelli is this the equivalent of ford over there?

 

no magnetti marelli actually make the components (including the ecu) for ford. they are not even badged as ford parts,

you wil notice that the ignition amp, starter motor, ecu and nearly all the engine sensors ona ford cosworth are made by MM.

the exact same MM parts are also used a quite a few other cars, lanci delta integrale, ferarri f40, etc

 

ok that helps very much

 

they didnt cross over is there anymore wrighting on the sencors?????

 

nope, sorry,

those ford finis numbers should work though, they are taken from fords own parts system

 

ok i was hoping that there was