Does anybody know how easy it is to change the TPS on a 3dr cossie & does it have to set up again. cheers

 

TPS normally side on side of throttlebody, there is just 2 bolts - and there is no setup to be done

 

yes ther is a set up to be done on the tps but a engine set up no and is a cunt of a job because you need a very short screw driver to get to the 2 littel screws

 

just unbolt hole throttle body

 

Yea i thought that m8, but do you just line up the new one in the same position as the old one.

 

you will probobly find that the position of the old one is almost exactly in the middle of the elongated holes on the TPS,,,, no more clues...

 

i didn't realise u had to setup tps, I best setup mine!

 

if you dont set it up how is the ecu to know when you have WOT?
you can normally set it up using a volt meter set on ohms, but i dont know what the readings are!
ford efi engines i belive reset themselves when you replace the tps.

 

not the webber ecu's though.... these need setting and then if its a P* learning aswell..