Welding question?
25-05-2006 | 10:51 AM
#1
Thread Starter
Virgin
Joined: May 2004
Posts: 2
Likes: 0
Welding question?
I am trying to weld repair panels to an Escort Mk1 front wing using a cheap gasless mig welder.
Even on the "Low" setting , it keeps blowing holes through the metal even with quick tack welding, what am i doing wrong?
Even on the "Low" setting , it keeps blowing holes through the metal even with quick tack welding, what am i doing wrong?
25-05-2006 | 11:45 AM
#2
Don't bother get ur self a gas mig welder 150 amps would be good and used proper gas (argonshield)
It will save time and money and give you a better job
IT WILL BE THE BEST MONEY YOU WILL SPEND MATE!!!!!!!and its always there to make money for mates etc
Sorry to say but cheaper welders and not very good
ie CLARK NON GAS
It will save time and money and give you a better job
IT WILL BE THE BEST MONEY YOU WILL SPEND MATE!!!!!!!and its always there to make money for mates etc
Sorry to say but cheaper welders and not very good
ie CLARK NON GAS
Thread
Thread Starter
Forum
Replies
Last Post