i have a set of VDO gauges,they are electrical and not mech (i have been told)boost i get but the oil pressure and the temp one i have no idea how to install them(if it is at all possible)do i need some sender thingys?
they have 3 male spades on the back ,+, -, and G which i presume is ground(earth).
any help on this one ,as in if possible and where to conect the oil press and temp too

 

Give Burtons a ring mate,they do all the senders etc you'll need,and they'll tell you where to stick them.

 

steady on old chap

 

PMSL

As said above. Could always give mr Rainbird a ring too.

 

so burton dont do them ,but deomon tweeks do VDO stuff,
but then they confused me by asking which connections i needed i know nowt about them so what conections do i need for oil pressure and temperature for the YB
HEEEEELP please