frog

If you have installed an in-dash TFT screen in your 3dr or sapph, could you post pictures up please ?

Any further information on how you did it, etc... would be much appreciated too.

Thanks in advance
Greg

R4N SS

iTrader: (6)

i have some of mine

frog

anyone ?

rsrob

Mrs Ginge

ines the same as rsrob, rans dont ya find the screens pointing to the floor like that

i had to loose me heaters due to that on me alpine screen

frog

RsRob and MrsB19bal (I suspect it's ginge wearing a skirt again ),

How did you mount it in the vents ? Can you get a plate to do it, or was this a custom job ?

How secure is it ?

Although I'd prefer to keep the top vents if at all possible

R4N SS

iTrader: (6)

the screen dont point to the floor altho it could with a few more degrees but the dash gets in the way. It was ok for me tho.

Ginge !

greg i made a plate out of MDF, if ya want ill make ya one for ya car and then ya just gotta trim in in leather and cut the center home out as i got a template the sizer of the heater vents

oh and dont forget to plug ya vents

if ya want me to knock one up just say as i got the mdf, template and i owe ya a favor too

frog

Hey ginge, you taken that skirt off now

Will bear the idea in mind, I am still looking for a way which won't loose me the air vents though Trust me to be complicated

Took the clock/computer display out today, I reckon I might be able to fit it in there by adapting the surround as you suggest (mdf + leather, vinyl or paint), only thing is that the air duct to the vents gets in the way at the back, so that might need some doctoring too

Why can't it be easy

Ginge !

the clock idea is a good one

but too much hard work hence why i went the lazy route, good thing is its best for viewing