Got to fit a set of grey injectors to my car this weekend, can someone
tell me how they fit them. I know someone had a picture of an
injector with the fitting kit on it, any chance someone can post that up?

Injectors have a blue shroud on the end (not I don't mean the covers)....

 

You need to cut the blue shroud off carefully.

http://wwwrsphysse.anu.edu.au/~amh11...l_injector.htm

 

parts laid out in order

 

My fittingkit looks like this:
http://www.cosworth-racing.dk/billedere/sc624.jpg

 

sirmark, yep thats it

 

How do you mount the yellow "thing" at the bottom of the injetctor? Is the blue "thing" supposed to be pulled off before mounting the fittingkit?

 

sirmark, you dont need the caps only the metal washers and rubber o rings, some people drill the ends off and fit them, i (well karl norris did it for me) just binned them as have many others

 

mine didnt use the end caps!

 

Can they be mounted in the manifold as they look here?
http://www.cosworth-racing.dk/billedere/IMG_2289.JPG

 

the plastic caps are also heat insualors and no to your picture

 

What am I supposed to do then?

 

Ok. But what does "binned" mean?

 

Cut them off

 

Drill a 7mm hole in the bottom of them is my advice as they also retain the spacer and rubber in the correct position.

 

slice them of with a stanley knife and drill a hole in the pintle cap as stu said

 

Ok. Now I'm totally confused. What is it I'm supposed to drill a hole in? The yellow cap?
Is the blue shroud supposed to be cut off at the top (all of it)?

 

drill the yellow cap


and cut the blue shroud off

 

Run without the yellow caps is my advice being a Bosch Dealer.

 

thanks mate

Why is it that the yellow cap isn't made with a 7 mm hole from the beginning....
So I cut all of the blue shroud off or am I supposed to leave some where the o ring and the spacer is being placed?

I know I ask a lot, sorry! But I just want to make sure that I do it right, because afterwards it's to late

 

no cut it all off and use the cap

 

sirmark......take off the blue shroud...leave cap off,the reason it aint the correct size is cause the injector is not for a cossie!!! ....on this part use 2 rubber o-rings to ensure a nice seal proof fit....on the top use the metal spacer and 1 o-ring.

 

use the cap as its a heat insulator